1. Three sections type straightening device, it's no need to adjust straighten function when rolled
materials under straightening process( from start to end), to ensure the material the same
flatness completely.
2. Superior products can not be finished with high accuracy only smoothing out of coil materials
may be accomplished,so material need to be straightened and stress moderately removed.
3. After straghtening, material can be curled upward, downward or flat easily.
4. The rollers bearings are lubricating free type,no need oiling, there is no problem of adherence oil
or dirt.
5. The drive unit is controlled by inverter to feed smoothly at speed synchronized with
the press machine.
6. Straightening upper rollers are available opening type which is easy to mop, clean rollers,
repair and maintain to ensure and enhance product quality.
7. Main axle of uncoiler supprots reeled material inner hole, independence power source and
control system, with inverter speed is adjustment, passed through circular guiding and left,
right adjustable wheel to support both sides of material stripe, guides material stripe into
the straightening machine, there is no scratching trace or damage on surface brilliance during
material stripe is moving forward, to reach target of adding product good rate and increase
production capacity, with much better competitive ability in the market.
Model |
SAL-2-200 |
SAL-2-300 |
Material Width (mm) |
200 |
300 |
Material Thickness (mm) |
0.1~0.6 |
|
Adjustment Method |
Independence 4 Points |
|
Speed |
16M/min |
|
Straightener Motor |
1/2hp + Inverter |
1hp + Inverter |
Uncoiler Motor |
1/2hp + Inverter |
|
Direction |
Left to Right |
|
Power |
AC220V,Three Phase (Single Phase) |
|
Material Weight (kg) |
500 |
※ Custom-made special specification is welcome